There is a settings option in the utility, but that only lets you remove the IPM icon from the system tray. After installation, the minimalist user interface presents you with two options: Continue or Exit. The software creates an 8GB GPT partition during the installation process, and after a glance at the Device Manager to verify the driver is installed correctly, you're off to the races. That extra warranty comes at an additional cost of $20 for the 9th-Gen K-series models, and it only applies to boxed processors bought at retail outlets. Intel doesn't provide warranty support for overclocking-induced chip death, but the company is happy to sell you a Performance Tuning Protection Plan (PTPP) that gives you a one-time return if your overclocked chip dies. Intel's disclaimer reminds you that overclocking is an inherently dangerous pursuit: Increased voltages and frequency can kill components and result in system instability, along with threatening data integrity, so you proceed at your own risk. With those requirements met, the software installation is fairly straightforward. You also have to disable all other software overclocking utilities before proceeding, and use the correct version of the install executable (one is for Hyper-Threaded chips, the other for chips without). The software also requires the motherboard to be set to UEFI boot mode and be updated to the latest motherboard firmware (versions unspecified). You can use the software to automatically create a new partition with a portion of your drives' unused storage space if the system drive is already fully provisioned. You'll also need a minimum of 8GB of system memory and 16GB of unallocated storage capacity.
I uninstalled it and manually cleaned all uninstall residue, then reinstalled and rebooted, but it still failed to open.Intel also has restricted support to Microsoft Windows 10 圆4 Edition Version RS5 (and newer). I tried to open Intel Extreme Tuning Utilities, but it failed to open. i did not make any changes and got into the system. On reboot it prompted that I had a new CPU and needed to press F1 to get into Setup. I changed the CPU cooling from air cooling to 240 water cooling and removed and reinstalled the CPU from the CPU snapper, reapplied the silicone grease and spilled a bit on the capacitor on the green bezel of the front CPU, but I cleaned it up. A reboot may be necessary if Intel Extreme Tuning Utility was just installed, otherwise download and install the latest version of Intel Extreme Tuning Utility from īefore, I was able to open Intel Extreme Tuning Utilities normally and tried to tune the CPU frequency to 4.7GHz using Auto Overclock.
Unable to start Intel® Extreme Tuning Utility because the drivers are not running. When trying to open the Intel® Extreme Tuning Utility (Intel® XTU), the system shows an error:
0 kommentar(er)
